after that the wiring continues until the sensor and arduino is attached with the body until it became as below picture but it is not fully attach as I only use double sided in case of troubleshooting:
Monday, September 16, 2019
Week 8 - Circuit, wiring installation, software arduino coding upload and syncing with Blynk
On this week, most of critical part is done, first is installing the servo motor to the body as in picture below:
after that the wiring continues until the sensor and arduino is attached with the body until it became as below picture but it is not fully attach as I only use double sided in case of troubleshooting:
after that the wiring continues until the sensor and arduino is attached with the body until it became as below picture but it is not fully attach as I only use double sided in case of troubleshooting:
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment