Week 6 - Actual circuit construction (Metal and Ultrasonic sensor)

As the main circuit is already constructed and waiting to be installed, I continue to construct the other 2 sensor which is the ultrasonic and metal sensor, this metal sensor is different from the original planned, but the shop mention that the function is the same as the previous sensor and it has longer life span.

While doing and studying the circuit function and all, I am searching for any wood shop around PJ area to fabricate my project body. It is to make sure that the price is affordable and as budget. The body dimension should be 40W x 36D x 42H in cm.

NOTE: This is an early stages of circuit construction and not fully measure to the project body or mainframe.

Week 5 - Workshop on Chapter 4, 5 and Abstract in Thesis Writing

This workshop is conducted at TTL2 by Dr. Imran, basically he explain about result and discussion to be put and analyse in the report writing. Below are the slide during the session.

Week 4 - Actual Circuit Construction (Arduino, Servo Motor and Voltage Regulator)

During this week, the actual circuit is constructed and the focus was to connect the LM 7596, Arduino UNO and the servo motor. Below are the picture of servo wire construction on going but not yet install at the project body as it is not begin yet;

Note that the circuit is not running yet due to incomplete circuit construction as it will be done when the project body is fabricated. This is an early stages of circuit construction and not fully measure to the project body or mainframe.

Week 3 - Circuit construction finalize in Proteus

During this week, the circuit from FYP1 will be used and it is finalize, but it is not functioning even after converting the coding into HEX file, it shows error as the functioning wifi is not in the software so it cannot function unless working wifi is available in PROTEUS. So the project will be constructed without simulation.

Below is the recap on the circuit

At the same time, some of the part is bougt, which is the

• Arduino UNO
• Servo Motor
• Wifi Module
• Ultrasonic sensor

The metal sensor is not bought yet as the one to be use is out of stock, as this project is not using IR sensor as mention in FYP1. Below are metal sensor thought to be use but out of stock :